Filter
Top Products
Chapter 1 Preparation — Start-up display
24 - ENGLISH
Start-up display
When the projector is switched on for the rst time after purchase as well as when [ALL USER DATA] in the [PROJECTOR SETUP] menu →
[INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen is displayed. Set them
in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
Focus adjustment
Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom and shift.
Refer to “Adjusting the focus, zoom, and shift” (x page 51) for details.
1) Press asqw to adjust the focus.
LENS
FOCUS
ADJUST
2) Press the <MENU> button to proceed to the initial setting.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press as to select the display language.
ENTER
1/4
Please select DISPLAY LANGUAGE.
INITIAL SETTING
SELECT
SET
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting)
Set [PROJECTION METHOD] depending on the installation mode. Refer to “Installation mode” (x page 33) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [PROJECTION METHOD].
1) Press qw to switch the setting.
2/4
INITIAL SETTING
FRONT/FLOOR
PROJECTION METHOD
Change the projection method if the screen display is
upside down or inverted.
CHANGE
SET
ENTER
2) Press the <ENTER> button to proceed to the initial setting.