Filter
Top Products
POWER
AUTO
SETUP
INPUT MENU
SHUTTER
VOLUME
ENTER
R OTAT E
RETURN
ENTER
STD
%
ENGLISH-29
Basic operation
Turning off the power
#
,
$
POWER button
POWER button on the projector
POWER button status
Red
Illuminated
The projector is in standby mode and image projection
is possible by pressing the POWER button.
A picture is being projected.
The lamp is cooling down after the power has been
turned off or while direct power off function is
operating.
The projector is preparing for projection after the
power has been turned on while the POWER button
on the projector is illuminated orange. (After a short
period, a picture will be projected.)
The projector is preparing for projection after the
power has been turned on while the POWER button
on the projector is illuminated red. (After a short
period, a picture will be projected.)
Flashing
Illuminated
Illuminated
Flashing
Green
Orange
Projector status
Press the POWER button.
BThe “POWER OFF” confirmation screen
will be displayed.
NOTE:
BYou can also turn off the power by holding down the POWER button for
at least 0.5 seconds.
NOTE:
BPress any button other than the POWER button to cancel the “POWER
OFF” screen.
BThe “POWER OFF” screen will disappear in five seconds.
#
%
POWER OFF
[POWER] OK
Power cord
Direct power off function
You can disconnect the power cord during projection or immediately after
use and move the projector. The cooling fan will operate by the internal
power supply to cool down the lamp.
BWhen this function is used, it may take more time for the lamp to turn back
on again compared to when the lamp cools down with the power cord
connected.
BDo not put the projector in the softcase while the POWER button on the
projector is illuminated.
Disconnect the power cord after the POWER
button on the projector illuminates red.
28-ENGLISH
CAUTION
If not using the projector for an extended period of time, disconnect the
power cord plug from the wall outlet.
BIf dust builds up on the power cord plug, the resulting humidity may
damage the insulation, which could result in fire.
BThis projector continues to draw approximately 3 W of power even when
the power is turned off.
Press the POWER button again.
BThe lamp unit will switch off and the picture will stop being projected.
(The POWER button on the projector will illuminate orange while the
cooling fan is still operating.)
$
NOTE:
BDo not disconnect the power cord while the files in the SD memory card
are being played back.