Filter
Top Products
ENGLISH-33
Useful functions
32-ENGLISH
Inserting and removing the SD memory card
Inserting
#Insert the SD memory card with the
label side facing upward until a click is
heard.
BThe input signal will switch to “SD”
automatically. If the projector is in
standby mode, the lamp will turn on
automatically, and then the input signal
will switch to “SD”.
Removing
#Push in the middle of the SD memory
card. (A click will be heard.)
$Remove the card.
NOTE:
BWe shall not be responsible for any damage, whether direct or indirect,
caused by the use of or by the fault of the product.
BWe shall not be responsible for any data corruption and loss caused by
the product.
Using the SD memory card
Information on the SD memory card (sold separately)
The SD memory card is a semiconductor memory with a size of 24 mm x
32 mm x 2.1mm, as small as a postage stamp, and is expected to be a next-
generation recording medium that will replace MDs (minidiscs), CDs
(compact discs) and cassette tapes. It allows repetition of data reading,
writing and deleting. This projector can be used to play back still image data
and moving image data that has been recorded by digital cameras as well as
presentation data whose format has been converted by ImageCreator 1.5.
Notes on using SD memory cards
BDo not disconnect the power cord and do not remove the SD memory
card while files are being played back. Failure to observe this may
result in data corruption or data loss.
BBe sure to make a backup of the data stored in the SD memory card.
Note that important user data may be subject to potential corruption
although it very rarely occurs.
BWhen using a miniSD
TM
card, be sure to attach the miniSD
TM
card
adapter. Insert and remove the miniSD
TM
card with the adapter
attached.
BIf only the miniSD
TM
card adapter is inserted into the SD memory card
slot, the projector will not operate correctly. Be sure to use the miniSD
TM
card adapter with the miniSD
TM
card inside.
B
Correct operation of a MultiMedia Card in the projector is not guaranteed.
BUse of a Panasonic SD memory card is recommended.
Data that can be played back
Only folder and file names that comply with the DCF standard will be
recognized. (Refer to page 66 for details on the DCF standard.)
Still image data:
The format for still images is Exif2.2-compliant JPEG.
BStill image data recorded by the LUMIX Panasonic digital camera.
BStill image data whose format has been converted by ImageCreator 1.5.
Moving image data:
The format for moving images is QuickTime Motion JPEG.
BMoving image data recorded by the LUMIX Panasonic digital camera.
ImageCreator 1.5
ImageCreator 1.5 is software that allows you to convert image formats for
presentation files made by Microsoft PowerPoint
®
to a format that can be played
back by this projector. You can download ImageCreator 1.5 from our website.
http://panasonic.co.jp/pavc/projector
Refer to the operating instructions for ImageCreator 1.5 that can also be
downloaded from the website above for details on operation.
NOTE:
BAlways be sure to check that the files in the SD memory card are not
being played back before removing the SD memory card. Failure to
observe this may result in data corruption or data loss.
NOTE:
BIf you try to force the SD memory card to go in the wrong way, it may
damage the SD memory card and the card slot.