Filter
Top Products
Powering ON/OFF
28
- ENGLISH
Basic Operation
Complete peripheral connections (with a 1 )
computer, VCR, etc.) before turning on the
projector.
Connect the projector’s AC power cord into an 2 )
AC outlet. The <ON(G)/STANDBY(R)> indicator
lights red. Open the lens cap.
Press the <3 ) > button to on the control
panel or on the remote control. The <ON(G)/
STANDBY(R)> indicator lights green and the
cooling fans start to operate. The preparation
display appears on the screen and the count
down starts.
After the countdown, the input source that was 4 )
selected the last time and the lamp power status
icon appear on the screen.
If there is no signal input when start on the 5 )
projector, or the current signal is missed while
operating the projector, the Video/Computer
selection window will be displayed on the screen,
please move the pointer to input source desired
by pressing the ▲▼ and the <ENTER> button.
And then follow the input signal guidance window
to correct the signal and connection.
If the projector is locked with a PIN code, PIN
code input dialog box will appear. Enter the PIN
code as instructed on the next page.
Note
When the [Logo select] function is set to [Off], the logo
z
will not be shown on the screen (
Æ
page 53).
When [Countdown off] or [Off] is selected in the [Display]
z
function, the preparation display will not be shown on the
screen (
Æ
page 53).
When the [Input search] function is set to [On 2], the
z
input signal will be searched automatically (
Æ
page 52).
When the [Direct on] function is set to [On], the projector
z
will be turned on automatically by connecting the AC
power cord to an AC outlet.
Turning On the Projector
(2)
(3)
(3)
Video/Computer selection
06
Selected Input Source and Lamp power
Lamp power status
The preparation display will disappear
after 30 seconds.