Filter
Top Products
Image adjust
ENGLISH -
47
Settings
Sharpness
Press ▲▼ to select [Sharpness].1 )
Press the <ENTER> button to display 2 )
the adjustment dialog box.
Press ◄► to adjust the setting value.3 )
Operation Adjustment
Adjustment
range
Press ►.
increase the
sharpness of the
image
Maximum
value 15
Press ◄.
decrease the
sharpness of the
image
Minimum
value 0
Note
When [Daylight View] is set to [On] or [Auto], the
z
[Sharpness] is disabled.
Gamma
Press ▲▼ to select [Gamma].1 )
Press the <ENTER> button to display 2 )
the adjustment dialog box.
Press ◄► to adjust the gamma value 3 )
to obtain a better balance of contrast.
Adjustments can be made between
z
0 and 15.
Noise reduction
Press ▲▼ to select [Noise reduction].1 )
Press the <ENTER> button to display 2 )
the adjustment dialog box.
Press ◄► to select the desired item.3 )
Off Disabled
L 1 Lower reduction
L 2 Higher reduction
Noise interference on the screen can be
z
reduced. Select one of the above options to get
smoother images.
[Noise reduction] cannot be selected when
z
[480p], [576p], [720p], [1 035i] or [1 080i] is
selected.
Note
When input video signal to the projector, [Noise
z
reduction] will become available.
Progressive
Press ▲▼ to select [Progressive].1 )
Press the <ENTER> button to display 2 )
the dialog box.
Press ◄► to select the desired item.3 )
An interlaced video signal can be displayed in
z
progressive mode. Select one of the following
options.
[Progressive] cannot be selected when [480p],
z
[576p], [720p], [1 035i] or [1 080i] is selected.
Off Disabled
L 1 For an active picture
L 2 For a still picture
Film For watching a lm
Note
When input video signal to the projector, [Progressive]
z
will become available.
Reset
To reset the adjusted data, all adjustments will return
to their previous gures.
Press ▲▼ to select [Reset].1 )
Press the <ENTER> button.2 )
A conrmation box appears and then select [Yes].
z
Note
To reset the adjusted data except [
z
Daylight View].
Store
Press ▲▼ to select [Store].1 )
Press ► or the <ENTER> button.2 )
Press ▲▼ to select one from Image 1 3 )
to 4 and press the <ENTER> button.
A conrmation box appears and then select [Yes].
z
Note
To store the adjusted data except [
z
Daylight View
].
Make sure you selected [Store] after adjusting
z
settings. Some settings can not be stored if not
registered with [Store] function.