Filter
Top Products
– Recharge the battery pack before using the Wireless Monitor again.
Pairing to the Base Unit
R T
he Wireless Monitor (
) can be used by pairing it to the Base Unit ( )
*
1
of the Wireless
Door Camera.
1
*1
:
Plug the AC adaptor of the Base Unit into the power outlet.
2
*1
:
Press and hold the pair button (B) located on the bottom side of the Base Unit
*1
for
about 3 seconds with a pointed object.
R Stop pressing the pair button (B) when the pair indicator (A) starts to slowly flash.
<Bottom view
*
1
>
A
B
3 : Place the additional Wireless Monitor ( ) on the Base Unit ( )
*
1
, and then
press MMENUN.
R Press MMENUN within 2 minutes of performing step 2.
4
: Press M N
(Monitor button) to start pairing.
R When pairing is completed, “PAIRING COMPLETED” is displayed.
Note:
R Pairing cannot be performed when another Wireless Monitor is accessing the Base Unit
*1
(for
monitoring or other purposes).
R The monitor number of the Wireless Monitor to be paired cannot be specified.
*1 Base Unit of the VL-SDM200BX.
To pair canceled Wireless Monitors
R P
erform the following operations within 2 minutes after pressing and holding the pair button of the
Base Unit (
) as explained in step 1 and 2 above.
1 P
ress MMENUN.
2 Select “ALL SETTINGS” by pressing arrow keys (MDN, MCN, MFN, or MEN), then press M
N
(Monitor
button) (“OK”).
3 Select “PAIRING/CANCEL” by pressing MDN or MCN, then press M
N
(Monitor button) (“OK”).
4 Select “PAIRING” by pressing MDN or MCN, then press M
N
(Monitor button) (“OK”).
5 Select “MONITOR”, then press M
N
(Monitor button) (“OK”).
6 Press M
N
(Monitor button).
7 To finish the operation, press MMENUN 2 times.
10
Getting Started