Filter
Top Products
12
9. Move the cursor to the AUDIO parameter with the C or
D button, then adjust the audio volume with the - or
+ button.
-: Decreases the audio volume.
+: Increases the audio volume.
10. Move the cursor to the STANDBY ON parameter with
the C or D button, then select the desired mode with
the - or + button.
These modes refer to the display mode in standby con-
dition when the STANDBY ON terminal is receiving
input from the outboard device.
MODE 1: Pictures are displayed with less brightness.
MODE 2: Monitor blackout, i.e., no picture is displayed.
IGNORE: Input signal is ignored. The display does not
change.
The factory default setting is MODE 1.
11. Move the cursor to the CH DISPLAY parameter with the
C or D button, then select either ON or OFF with the
- or + button.
This item lets you enable or disable the display of the
input channel in the upper left corner of the monitor
screen.
ON: Always displays the input channel.
OFF: Displays the input channel for a few seconds
after the input selection is made.
The factory default setting is OFF.
12. To exit the Display Setting menu, press the MENU but-
ton to return to the previous screen.
3. Move the cursor to the BRIGHT, CONTRAST, SHARP-
NESS, COLOR, TINT parameter with the C or D but-
ton, then adjust the level of the selected item with the
- or + button.
While the level of an item is being adjusted, the indica-
tor displays the changed level as shown below.
4. Repeat the above procedure to adjust the level of the
other items.
5. To return to the menu setup display, press the MENU
button.
6. Move the cursor to the AFC (Automatic Frequency
Control) parameter with the C or D button, then select
either LONG or SHORT with the - or + button.
LONG: Receives input including noise or jitter such as
VCR playback or TV program.
SHORT: Receives input other than the above such as
camera output.
The factory default setting is SHORT.
7. Move the cursor to the 3.58 TRAP parameter with the
C or D button, then select either ON or OFF with the
- or + button.
ON: Enables the 3.58 MHz trap filter to decrease the
cross color noise.
OFF: Disables the 3.58 MHz trap filter. Normally select
this mode.
The factory default setting is OFF.
8. To reset the items on the page to the default settings,
move the cursor to NORMAL SETTINGS with the C or
D button, then press the - or + button to restore the
factory default settings.
BRIGHT 0
CONTRAST 0
SHARPNESS 0
COLOR 0
TINT 0
Darker Brighter
Less More
Soft
Sharp
Less More
Reddish
Greenish
Item Effect Indicator
BRIGHT
CONTRAST
SHARPNESS
COLOR
TINT
PAGE1
BRIGHT 0
CONTRAST 0
SHARPNESS 0
COLOR 0
TINT 0
AFC SHORT
3.58TRAP OFF
NORMAL SETTINGS
- or +
PAGE1
BRIGHT -12
CONTRAST +8
SHARPNESS -16
COLOR -6
TINT -2
AFC LONG
3.58TRAP ON
NORMAL SETTINGS