Filter
Top Products
18
Wiring the DC Input Power Source
Follow these steps:
Step 3
Slide the exposed area of the 6-gauge wire
into the ground lug, and use the crimping
tool to crimp the lug to the wire.
Step 4
Using the ratcheting screwdriver, torque the ground lug screws to 15 lbf-in. (240
ounce-force inches [ozf-in.]) to attach the ground lug to the switch.
Step 1
On the terminal block connector, identify the positive and negative feed positions.
Step 2
Strip each of the four wires coming from the
DC power source to 0.27 inch (6.6 mm)
0.02 inch (0.5 mm). Do not strip more than
the recommended amount of wire.
Step 3
Insert the four exposed wires from the DC-input power source into the terminal block plug,
matching positive to positive and negative to negative for both the A and the B feed wires.
0.27 inch (6.6 mm)