Filter
Top Products
11
Table 6. General Management Configuration Options (2 of 2)
Option Comments/DescriptionFactory 2Factory 1
Com NetMask:
Edit Edit
The Subnet Mask needed to
access the device when the COM
Com NetMask:
Clear Clear
access the device when the COM
port is configured for SNMP.
Com Link:
PPP PPP
The link layer protocol for the COM
Com Link:
SLIP SLIP
The
link
layer
protocol
for
the
COM
port when configured for SNMP.
IPBusMast:
Enable Enable
Specifies whether the device is the
IPBusMast:
Disab Disab
Specifies
whether
the
device
is
the
IP Bus Master.
None None
Def Netwk:
IPBus IPBus
The default networkconnection
Def Netwk:
Com Com
The default network connection.
FDL FDL
Table 7. Management Trap Configuration Options (1 of 2)
Option Factory 1 Factory 2 Comments/Description
Num Trap Mgrs:
1
2–6
1
2–6
The number of trap managers
supported by the device.
Trap
n
IP Adr:
Edit Edit
Specifies the IP address for each
trap manager. This configuration
Trap
n
IP Adr:
Clear Clear
trap
manager
.
This
configuration
option is repeated for all
n
managers.
None None
Tra
p
n
Dst:
IPBus IPBus
S
p
ecifies the network destination
T
rap
n
D
s
t
:
Com Com
S
pec
ifi
es
th
e ne
t
wor
k
d
es
ti
na
ti
on
for Trap Manager
n
.
FDL FDL
Disab Disab
Gen Trap:
Warm Warm Specifies the general trap types to
enable: WarmStart Authentication
Gen Trap:
Auth Auth
pgpyp
enable: WarmStart, Authentication
Failure or both.
Both Both
Failure
or
both
.
Entp Trap:
Enab Enab
Specifies whether the
EnterpriseSpecific trap type is
Entp Trap:
Disab Disab
p
EnterpriseSpecific trap type is
enabled.