Filter
Top Products
3. DSL Card Configuration
8000-A2-GB26-50 April 2001
3-23
Configuring Static Users
You must perform this procedure if you have static users unless you are using a
DSL Router and operating in Standard mode set on SCM card. You can configure
up to 32 host entries or subnet entries per DSL interface. For more information
about the fields listed in this procedure, see Table 3-4, Bridge Options
.
NOTE:
Do not assign the same subnet to multiple ports.
Procedure
From the Hotwire – DSL menu:
1. Follow this menu selection sequence:
Configuration
→
Bridge
→
Client VNID Table
(
A-E-E
)
2. Enter the name of the interface at the
DSL Interface Name:
prompt. Enter
1
through
4
for 4-port DSL cards,
1
through
12
for 12-port DSL cards, or
1
through
24
for 24-port DSL cards.
3. Type
0
or press Enter at the
User:
prompt.
4. Enter the IP Address of this user at the
Enter client IP address
(nnn.nnn.nnn.nnn):
prompt. Enter the IP addresses of all clients behind
the nonrouter SN if IP Scoping or IP Filtering is enabled.
If using a DSL Router, enter its IP address. Also enter the IP address of all
clients behind the DSL Router if IP Filtering is enabled.
5. Enter the subnet mask at the
Enter Subnet Mask (nnn.nnn.nnn.nnn):
prompt.
6. When using a subnet with a nonrouter SN, enter the IP address of the next
hop router for this client at the
Enter IP address of next hop router
(nnn.nnn.nnn.nnn):
prompt. The address used must be part of the
subnet that is attached to the nonrouter SN. When using a DSL Router, enter
the IP address of the NHR.
7. Enter the VNID for this user at the
Input VNID ID:
prompt. If VNID tagging
is disabled,
None
appears in this field.
8. Enter
yes
at the
yes/no:
prompt to save your changes.
NOTE:
Static IP address configuration is not required when the DSL port is
configured in Standard mode.