Filter
Top Products
10
7. If the cable length is longer than 100 feet (30 meters), set the LBO on the T3
Network Interface Options configuration screen to Long. The default is Short. See
the iMarc SLV Configuration Reference.
Connecting the Ethernet Port
The Ethernet port provides a 10/100BaseT connection that can be used for Telnet, FTP,
and SNMP access to the Probe.
Procedure
To connect the Probe to an Ethernet hub, switch, or NIC:
1. Select the correct cable:
— To connect the LAN port to a hub, use a standard Ethernet MDI cable
— To connect the LAN port to a NIC, use an Ethernet MDIX (crossover) cable
2. Insert the 8-pin modular connector of the cable into the Ethernet jack on the Probe.
It locks in place when it is fully seated.
3. Fix the cable to the rail with a cable tie or other strain relief device.
4. Connect the other end of the cable to your LAN or NIC.
05-17704
LAN
Rx Tx Rx Tx
NETWORKSUBSCRIBER
ETHERNET MODEM CONSOLE
POWER
ALARM
TEST
OK
YEL
AIS
LOS
OOF
SUBSCRIBER
NETWORK
LCV
RD
RX
TD
TX
ATMC
ATMS