Filter
Top Products
3. Configuration Options
3-16 December 2002 9000-A2-GB31-00
System Alarm Relay
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether an alarm condition for the unit will activate the system alarm relay. The
alarm relay is deactivated when the condition causing the alarm is corrected. If more than
one alarm condition is present, the alarm relay remains active until all alarm conditions
are cleared.
You can also deactivate an alarm via the System Alarm Relay Cut-Off selection from the
Control menu; however, the alarm itself is not cleared. When another alarm condition is
detected, the alarm is reactivated again, requiring another manual deactivation of the
alarm relay.
Display Conditions – This option only appears for a FrameSaver SLV 9128 installed in
the 9000 Series Access Carrier.
Alarm conditions are:
Alarm Indication Signal (AIS) received at the Network, DSX-1, or PRI interface
Continuous Loss of Signal (LOS) condition at the Network, DSX-1, or PRI interface
CTS Down
DBM Download Required
DBM BRI Card Failed
Device Fail
DLCI Down
DTR Down
Ethernet Link Down
Excessive Error Rate (EER) detected at the Network or PRI interface
Internal Modem Failed
ISDN Network Failure
LMI Down
Network Communication Link Down
Out of Frame (OOF) at Network, DSX-1, or PRI
Primary or Secondary Clock Failure
Power Supply/Fan Failure
RTS Down
Self-Test Failure
SLV Latency Exceeded
SLV Timeout
Suboptimal (Maximum) Link Rate Cannot be Achieved
Two Level-1 Users Accessing Device
Yellow Alarm Signal on the Network, DSX-1, or PRI interface
Enable – Activates alarm conditions on the system alarm relay when an alarm condition
occurs.
Disable – Does not activate the system alarm relay when an alarm condition occurs.
Table 3-6. General System Options (3 of 3)