Filter
Top Products
2.0 INSTALLATION
2.1 Unpack and Inspect the SAM2000G
If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877-
638-2638 (1-603-427-0600 for international customers) or support@nettonet.com
.
2.2 Install the SAM2000G in an IP DSLAM Chassis
Net to Net Technologies' IP DSLAM interface modules are hot swappable; installing or removing an
interface module while the chassis is powered up does not affect the operational status of other
interface modules within the chassis. The IPD12000 is a fourteen slot chassis; slots 1-12 are for
interface modules such as the SAM2000G, slots 13 and 14 are reserved for MUMs. Interface
modules may be placed in any order in slots 1-12. The IPD4000 is a five slot chassis; slots 1-4 are
for interface modules, slot 5 is reserved for a MUM.
z
Align the SAM2000G with the module guides in the slot chosen for installation (slot 1-12 on
the IPD12000 or slot 1-4 on the IPD4000).
z
Slide the SAM2000G firmly into the chassis. DO NOT USE EXCESS FORCE.
z
Secure the SAM2000G by tightening the fastening screws on the module faceplate.
z
Verify that the PWR (Power) LED on the SAM2000G faceplate is illuminated.
2.3 Connect the SHDSL Line(s)
Plug the SHDSL cable into the RJ21 port, of the chosen slot, on the back of your IP DSLAM. Verify
your connections; the SHDSL LK LED for each connected port will illuminate solid or pulsing green.
Link-up time for connections between the SAM2000G and remote SHDSL modems can vary from
one to five minutes depending on the quality, gauge and distance of the copper cables. Default
bandwidth for the SAM2000G is 272 kbps.
CAUTION
Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when
handling this equipment.
NOTE
There must be a Multiplexer Uplink Module (MUM) installed in your IP DSLAM chassis in order for interface
modules to operate.
210-0000026 rev07