Filter
Top Products
Page 44
incommunicable. If you have changed the IP Address of the Bridge, make
sure that your Management/iSCSI Host computer is on the same subnet as
the modified IP Address. If you do not remember what settings you’ve
modified on your Bridge, you can always return to factory default settings
by pressing and holding the reset button down for 15 seconds.
D. Factory Defaults.
The iS5xx iSCSI Bridge is initially sent out with factory default settings for your
Web-based utility. When you press and hold the reset button down for 15
seconds, the factory default settings below are programmed back into your unit.
a. Login page.
I. Username: admin
II. Password: password
III. MAC Address: <unique MAC address programmed at
factory>
b. Web Port page.
I. Use iSCSI Port Settings: No
II. IP Address: 192.168.1.200
III. Subnet Mask: 255.255.255.0
IV. Gateway: <None>
V. Web Port: 4443
c. SCSI Bus page.
I. ID (00-15): 7
II. Termination: On
III. Termination Power: On
IV. Force Single Ended SCSI: Off
V. Force Ultra SCSI: Off
d. ISCSI Target page.
I. Obtain IP Automatically: No
II. IP Address: 192.168.0.200
III. Subnet Mask: 255.255.255.0
IV. Gateway: <None>
V. iSCSI Name Prefix: iqn.1995-10.com.paralan-<last 4 digits
of serial number>:
VI. iSCSI Protocol Port: 3260
VII. Max Connections: 16
VIII. Authentication Method: None