Filter
Top Products
OnSite Model 2603 & 2620 Quick Start Guide 3
1.1 Models with external AC adaptor
1. Connect female plug of the AC power cord to the AC adapter provided.
2. Connect the barrel-type connector of the AC adapter to the barrel-type Power jack
on the OnSite router.
3. Insert the male plug of the AC power cord into an AC power outlet (100–240
VAC).
1.2 Models with internal AC power supply
1. Insert the female end of the AC power cord into the internal power supply connec-
tor.
2. Connect the male end of the power cord into an AC power outlet (100–240 VAC).
1.3 Models with internal DC power supply
1. Strip insulation 1/4-inch from the electrical wires that will connect the DC power
source to the OnSite router.
2. Connect the positive (+) terminal from the power source to the positive (+) termi-
nal on the OnSite router.
3. Connect the ground terminal from the power source to the ground terminal (E) on
the OnSite router.
4. Connect the negative (-) terminal from the power source with to the negative (-)
terminal on the OnSite router.
Figure 1.
Connecting the DC power supply
Note “+”, “E”, and “-” may be unlabeled.
1.4 Power-up indication
The Power LED blinks as the OnSite router is powering up. When the Power LED stops
blinking and remains lit, the router is ready for you to configure.
2.0 Configure the IP address
The OnSite router is shipped with a factory-configured IP address assigned to the
Ethernet LAN port (green outline). The address is 192.168.200.10/24. In most cases,
you must change the address to be on the same subnet as your PC, as described in the
+E-