Filter
Top Products
4 OnSite Model 2603 & 2620 Quick Start Guide
procedures below. If you are not sure which IP address to use for your installation,
contact your network administrator.
2.1 Connecting a PC and logging in
1. Using the included combination RS232/Ethernet cable and DB9-RJ45 adapter,
connect a PC’s serial port to the OnSite router’s Console port (see figure 2).
Figure 2.
Connecting OnSite router to the PC’s serial port
2. Start a HyperTerminal session on the PC using the settings:
9600 bps, 8 data bits, 1 stop bit, no parity, no flow control
3. Log in to the OnSite router using the factory-default login and password:
Login: superuser
Password: superuser
Login successful
2.2 Modifying the IP address
1. Display current IP interface settings for the OnSite Ethernet LAN port.
ip list interfaces <enter>
IP Interfaces:
ID | Name | IP Address | DHCP | Transport
---|------|----------------|----------|--------------
1 | ip1 | 192.168.200.10 | disabled | <eth1>
----------------------------------------------------
2. Modify the IP address for the LAN port according to your network requirements.
ip set interface ip1 ipaddress 10.10.10.5 255.255.255.0
Note The above IP address (
10.10.10.5/24) is only an example. You must
choose an IP address on the same subnet as your PC.
3. Verify the new address is correct and save it in system boot memory.
ip list interfaces <enter>
system config save <enter>
L
in
k
F
r
a
m
e
T
D
R
D
L
i
n
k
1
0
0
M
T
x
R
x
W
A
N
E
t
h
e
r
n
e
t
P
o
w
e
r
Co
n
s
o
l
e
ipL
i
nk
G
a
t
ew
ay
H
ig
h
S
p
ee
d
W
A
N
A
c
c
ess
Ro
ut
e
r
M
o
del
2
6
0
3
Connect to Console port
Serial port
PC with
terminal emulator