Filter
Top Products
OnSite Model 2603 & 2620 Quick Start Guide 5
Now you can connect the OnSite router to your local IP network and complete the
remaining configuration from your PC using a standard web browser.
3.0 Connect to the local IP network
Connect the OnSite router’s (green) Ethernet port to the same Ethernet segment as your
PC (see figure 3).
Note The Model 2620 does not have an MDI-X switch, so you must use a
cable wired straight-through to connect the Model 2620’s Ethernet port
to the IP network.
If you have a Model 2603, press the MDI-X switch until the Ethernet Link LED turns on.
Figure 3.
Connecting the OnSite to the local IP network (Model 2603/K shown)
You can check the network connection with the ping command. For example, you
would ping 10.10.10.5 from your PC.
4.0 Log onto the web management interface
You will now access the web management Graphical User Interface (GUI) to configure
the OnSite using a standard web browser (such as Internet Explorer or Netscape
browser).
1. At your PC, open a web browser and enter the IP address you assigned to the
OnSite router’s Ethernet LAN port in step 2 of section 2.2 “Modifying the IP
address” on page 4.
2. Log in to the web management home page using the username superuser and the
password superuser.
C
r
o
s
s
o
v
e
r
10
/
1
0
0
E
t
h
e
r
n
e
t
WA
N
Po
w
e
r
M
D
I
-
X
R
X
T
X
Connect to
Ethernet port
Ethernet port
MDI-X switch
PC