Filter
Top Products
4 OnSite 2888 Quick Start Guide
2.0 Setting the IP address
2.1 Default IP configuration
The factory default IP settings are as follows:
•
LAN port (ETH 0): IP address: 192.168.200.10, Netmask: 255.255.255.0, DHCP client
If this address conflicts or does not match with your network, it must be changed.
2.2 Connecting to the PC and logging in via the Ethernet port
1. To access the OnSite configuration, connect a PC’s Ethernet port to the OnSite’s LAN port (see Figure 3).
Use the black Ethernet cable included with your OnSite for this purpose.
Figure 3. Connecting to the PC’s ENET port
2. Configure your PC’s Ethernet port to be on the same subnet as the OnSite.
3. Open a Telnet connection to the default LAN IP address of the OnSite (192.168.200.10).
Log into the unit using the following:
login: admin
password:
PC
Connect to Ethernet LAN
ports, ETH 0 and ETH 1
IPLink 2888
192.168.200.10
Ethernet port
ETH 0/0
ETH 0/1
Console
RS-232
Power
~ 120-240V, 50/60 Hz, 1A
0/0
0/1
0/2
0/3
T1/E1