Filter
Top Products
Introduction
17
3088/I Getting Started Guide
2 • Initial configuration
Introduction
The Model 3088/I (see figure 2) has two configuration modes: RS-232 console and web page GUI software.
Figure 2. Model 3088/I
The RS-232 console is used for the initial configuration of the IP address and mask. Subsequently the easiest
method is to use a standard web browser to complete the configuration.
The 3088/I is Plug ‘n’ Play with the Model 3096RC G.SHDSL concentrator card or compatible
G.SHDSL card.
Power up the NTU
Your NTU comes with an external AC adaptor with detachable power cord. (Also refer to “Power-up” on
page 33.)
AC power-up
1.
Connect female plug of the AC power cord to the AC adaptor provided.
2.
Connect the barrel-type connector of the AC adaptor to the barrel-type power jack on the
RocketLink-G NTU.
3.
Insert the male plug of the AC power cord into an AC power outlet (100–240 VAC).
DC power-up
The 36-60 VDC DC to DC adapter is supplied with the DC version of the Model 3088/I. The black and red
leads plug into a DC source (nominal 48VDC) and the barrel power connector plugs into the barrel power
supply jack on the 3088/I. (See figure 3).
Ensure that the power cable used with the external power adapter meets all
applicable standards for the country in which it is to be installed, and that it is
connected to a wall outlet which has earth ground.
WARNING