Filter
Top Products
col
Distance between the
left edge
of the print area
and the left edge of the graphic image. Must be
measured in units specified above.
NOTE: The first dot on the printhead starts 0.060" from
the left edge of the supply.
mode
Imaging mode. Enter 0 in this parameter. 0 is
the only value supported on the 9406 printer.
name
Assign a name to the graphic image. The name
must be 1 to 8 characters in length. Enclose in
quotation marks. Example: "Name"
Example
{G,5,A,R,G,96,48,0,"Letter A"
• Graphics Header
• Image is identified by number 5
• Image being Added
• Image stored in RAM
• Image uses Graphic (dot) measurement
• Image will be placed 96 dots (1/2 inch) from bottom of
print area
• Image will be placed 48 dots (1/4 inch) from left edge of
print area
• Imaging mode is 0
• Image is called Letter A.
NOTE: The printer uses the row and column locations in the
Graphics Header only if a format does not reference
this graphic.
If a format references this graphic image (see Chapter
4, "Placing the Graphic in a Format), the graphic field in
the format determines the row and column locations.
Defining Graphic
Images
3. Defining Graphic Images
3-3