Filter
Top Products
9
Black
Mark
Sensor
On-
Demand
Sensor
Platen
Roller
Cleaning the Pinch and Feed Rollers
1. Turn off the printer and open the supply cover.
2. Remove the supplies.
3. Turn the platen roller with your fingers and run a dry, lint-free cloth across
the pinch and feed rollers as they turn. Make sure the rollers are clean all
the way around. If that does not work, use a cloth dampened slightly with
distilled water.
4. Clean any adhesive buildup you see as the rollers turn.
5. Reload the supplies after the printer dries.
Cleaning the Black Mark Sensor
1. Turn off the printer and open the supply cover.
2. Remove the supplies
3. Clean the black mark sensor with a dry cotton
swab.
4. Reload the supplies and close the supply
cover.
Cleaning the On-Demand Sensor
1. Turn off the printer and open the supply cover.
2. Remove the supplies.
3. Open the label deflector.
4. Clean the on-demand sensor with a soft cloth
moistened with distilled water.
5. Reload the supplies and close the label
deflector and supply cover.
Cleaning the Platen Roller
Clean the platen roller when you see significant
adhesive build-up or when a label is wrapped
around the platen roller.
1. Turn off the printer and open the supply
cover.
2. Remove the supplies. See “Removing
Supplies” in Chapter 3 for more information.
3. Hold the printer upright and gently press
down on the label deflector. It may be stiff.