Filter
Top Products
34
MO9740 Manual
10. Connecting the Printer and Computer
Note :
The power supply barrel connector must be inserted into the
power jack on the back of the printer before connecting the
communication cables.
The 9742 printer is equipped with a ninepin Electronics Industries
Association (EIA) RS-232 serial data interface, a standard
Centronics parallel interface and USB interface.
In either case, you must supply the required interface cable for
your application!
Note :
This printer complies with FCC "Rules and Regulations" , Part
15, for Class A Equipment, using fully shielded six-foot data
cables. Use of longer cables or unshielded cables may
increase radiated emissions above the Class A limits.
Serial (RS-232) Interface Requirements
The required cable must have a nine-pin "D" type male connector
on one end, which is plugged into the mating serial port located on
the back of the printer. The other end of this signal interface cable
connects to a serial port at the host computer.
For technical and pin-out information, please refer to the
Reference Technical Information-Interface Specification on page
55 of this booklet.
35
MO9740 Manual
Power Jack
RS232 Serial Port
Parallel Port
USB port