Filter
Top Products
Battery Life
If you leave the battery charger
plugged in and constantly charging
when the MWS is not in use,
the battery life is maximized for the
application. The charger will not
overcharge the batteries.
The MWS has Battery Status
Signal Lights to indicate the battery
status as follows. The following
voltages are nominal (not exact)
and should be used for reference.
Flashing Red/
Orange
Warning! The batteries need immediate charging.
Voltage is below 11.25V (one battery) or 22.5V (two
batteries). The MWS beeps (10 seconds beep on and
five minutes no beep) to alert you of this condition.
Flashing Yellow Caution! The batteries are getting low. The voltage is
between 11.25V and 11.75V (one battery) or 22.5V and
23.5V (two batteries).
Flashing Green Go! The voltage is above 11.75V (one battery) or 23.5V
(two batteries). The batteries are charged to
approximately 75% or better capacity.
Immediately plug the power cord into the wall socket and charge
the batteries when you hear a beep/chirp and the signal light
flashes red/orange.
12 Volt switch levels = +/- 0.15V; 24 Volt switch levels = +/- 0.25V
3-4 Charging the Batteries
Signal
Lights