Pelco VBP3000 Computer Monitor User Manual


 
H. Installing the Unit with Bag Between the Driver/Passenger Seat
Option 1
(Refer to Figure 7)
Figure 7
1. Take one of the supplied straps and connect the latch to the upper metal ring on the
left side of the bag. Attach the "S" hook to the same ring after looping the strap around
the headrest of the driver's seat. Repeat this process for the right side (Passenger
Seat).
2. Take another strap and connect the latch to lower metal ring on the left side of the Bag.
Attach the "S" hook to the same ring after looping the strap around the driver's seat rail.
Repeat this process for the right side. In some vehicles, it may be necessary to attach
the "S" connector to the rail directly, as it may not be long enough to reach back to
the ring. Also, depending on the desired angle, you may need to attach the latch to
either the front or the rear ring on the bottom of the Bag, depending on your vehicle.
3. Adjust the straps tightlyso that the bag is secured.
4. Unzip the bag on both the left and right side. The system will lean against the front
of the bag at about a 15-degree angle when the zippers are fully unzipped. Adjust the
zippers so that the unit is at the proper angle to allow the screen to be adjusted for
the best viewing angle.
66
66
6
7