Filter
Top Products
C808M-G (4/05) 15
6. For channels with cameras connected to the video inputs, set the front panel switches to the AUTO position. All unconnected video inputs
should have their channel switch set to the BYPASS position.
NOTES:
•
VS5004 and VS5008 with one-monitor configuration:
All channels with a switch set in the AUTO position will automatically sequence
through the monitor. To view one specific channel continuously, set the corresponding switch to the MONITOR position. To remove a
channel from the sequence, set the corresponding switch to the BYPASS position.
•
VS5008 with two-monitor configuration:
– With all channel switches in the AUTO position, both monitors sequence simultaneously.
– Monitor 2 can be manually switched to any channel for continuous viewing by setting the desired channel’s switch to the MONITOR
position. If multiple channels are set to MONITOR, only the lowest numbered channel will be displayed. This does not affect the
sequencing for Monitor 1.
– To remove a channel from the sequence, set the corresponding switch to the BYPASS position.
7. Connect the AC adapter to the 12 VAC input plug on the rear of the VS5004 or VS5008. Connect the transformer to a 120 VAC (VS5004 or
VS5008) or 230 VAC (VS5004/220 or VS5008/220) power source. After power up, the switcher will begin sequencing.
8. Using a screwdriver, adjust the DWELL interval control to the desired setting. This control adjusts the interval time from a minimum of
1 second to a maximum of 70 seconds nominal. To increase the interval, turn the control clockwise. To decrease the interval, turn the
control counterclockwise. The DWELL interval control is a precision 15-turn potentiometer. Each complete turn of this control will adjust the
time interval by approximately 4 to 5 seconds.