Pentax 3, 3 Plus Printer User Manual


 
for more information. Note that every driver can be installed manually
if necessary.
Browse the CD to locate the “Setup” or “Install” program for your
operating system, then double click on the “.exe” program icon and
follow the on-screen instructions.
If the installation does not proceed as explained above, contact Pentax
Customer Service.
Configuration Utility
The disk supplied with the PocketJet3 and 3Plus printers contains a
printer setup program that allows the user to modify the storable
configuration parameters of the printer.
While some features will be of potential benefit to all users, those
whose host devices are capable of sending only text and not special
commands will find this especially helpful in presetting margins,
page sizes and the like.
This program, PJ3CONFIG.EXE (and PJ3plusCONFIG.EXE), is
accompanied by the file PJ3FACTORY.CFG (and
PJ3plusFACTORY.CFG). The PJ3FACTORY.CFG file contains the
information that matches the printer configuration as it was shipped.
As you modify this information for your preferences and save them to
the printer, the file PJ3DEFAULT.CFG will be created with your
preferences. The PJ3CONFIG.EXE and any *.CFG files should be
located in the same folder when running the program.
Installing the Configuration Program:
When using the CD Installation program to install drivers for Windows
XP, 2000, Me, 98, and 95, the Configuration Program’s SETUP
utility will be launched at the same time automatically. You must
follow the onscreen instructions to complete the installation.
To install the Configuration Program independently, browse the CD
into the <CD-Drive>:\<PJ3 or PJ3plus>\Config folder, and then
double-click the PJ3ConfigSETUP.EXE (or
PJ3plusConfigSETUP.EXE), and follow the onscreen instructions.
Page 9