Filter
Top Products
Line Service Commands
86 IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7
Set UDP
ripaddr
The IPv4 address of the remote end of the SLIP link. Choose an address that is part of
the same network or subnetwork as the IOLAN. If your user is authenticated by the
IOLAN, this remote IP address will be overridden if you have set a
Framed IP Address
for the user. If your user is authenticated by RADIUS and the RADIUS parameter
Framed-Address is set in the RADIUS file, the IOLAN will use the value in the
RADIUS file in preference to the value configured here.
vj-comp
This determines whether Van Jacobson compression is used on this link; that is, whether
you are using SLIP or C-SLIP (compressed SLIP). The choices are
On (C-SLIP) or Off
(SLIP). The default is
On. C-SLIP greatly improves the performance of interactive
traffic, such as Telnet or Rlogin.
If your user is authenticated by the IOLAN, this VJ compression value will be
overridden if you have set a
Framed Compression value for a user. If your user is
authenticated by RADIUS and the RADIUS parameter
Framed-Compression is set in
the RADIUS file, the IOLAN will use the value in the RADIUS file in preference to the
value configured here.
routing
Determines the routing mode (RIP, Routing Information Protocol) used on the SLIP
interface as one of the following options:
z None—Disables RIP over the SLIP interface.
z Send—Sends RIP over the SLIP interface.
z Listen—Listens for RIP over the SLIP interface.
z Send and Listen—Sends RIP and listens for RIP over the SLIP interface.
This is the same function as the
Framed-Routing attribute for RADIUS authenticated
users. Default is
None.
Description Configures the UDP settings for the serial line.
User Level Normal, Admin
Syntax
set udp line .|<number>|* entry 1|2|3|4
both auto-learn|specific <UDP_port> [<start_IP_address>]
[<end_IP_address>]
set udp line .|<number>|* entry 1|2|3|4 in
any-port|auto-learn|specific <UDP_port> [<start_IP_address>]
[<end_IP_address>]
set udp line .|<number>|* entry 1|2|3|4 out <UDP_port>
[<start_IP_address>] [<end_IP_address>]
set udp line .|<number>|* entry 1|2|3|4 none
Options entry 1|2|3|4
Selects which of the 4 available entries we wish to define/modify. For each entry the
user can specify a different IP address range, UDP port and direction of data flow.