Filter
Top Products
Perle PoE/PoE+ 10/100 Ethernet Media Converter
Installation Guide
3
Installation
The default DIP switch settings (all switches in the UP position)
will work for most installations.
These are the steps required to configure the Perle S-110P
Ethernet media converter:
1. Insert SFP Module (SFP Model only).
2. Set the DIP switch settings (if required).
3. Set the Powering Option Jumpers (if required).
4. Install and connect the fiber cable.
5. Install and connect the copper cable.
6. Install the Power cord Relief clip (optional).
7. Power up the media converter.
Power Sourcing Pinouts
When Power Sourcing is enabled on a copper port, the S-110P
will provide power to the connected PD device over the Ethernet
cable (see PSE function on Dip Switch configurations). The wire
pairs on the cable used for delivering power will depend on the
device. The following options are available.
PoE Option
RJ-45
Alternative A Alternative B Legacy
1 positive
2 positive
3 negative
4 positive negative
5 positive negative
6 negative
7 negative positive
8 negative positive