Filter
Top Products
7.
Grasp the lamp holder handle and carefully pull the lamp
holder out of the projector.
8.
Carefully remove the new lamp housing from its package. Do
not touch lamp or point lamp housing opening at anyone. Do
not drop, as the impact may cause the lamp to break.
9.
Place the lamp holder in the guiding slots and insert into the
lamp compartment.
10.
Tighten the screws.
11.
Replace the cover and tighten the screws.
12.
Plug the projector back in by inserting the mains lead in the
Mains socket.
13.
Press the Stand by On button to switch on the projector.
14.
Reset the lamp life time (see ‘Resetting the lamplife time’).
15.
Properly dispose of the old lamp.
Notes:
–
When replacing the lamp, always use the same type of lamp
LCA3115/00, 12NC 8670 931 15009).
–
Please dispose of lamp in special chemical disposal bins.
Resetting the lamplife time
1.
Press Menu.
– The menu bar appears on the screen.
2.
Use cursor control to
select Settings in the
menu bar.
3.
Use cursor control to
select Lamp counter in
the sub menu.
4.
Press OK for 3 seconds to reset the lamp counter.
5.
If required, select another item you wish to adjust or press
Menu to exit.
Display
Language
Keystone correction
Start-up screen
Lamp counter
System informatyion...
Factory reset
(more)
Lamp
0 hours
Lamp counter shows the operating hours of the
lamp. It is suggested to reset when a new lamp is
inserted. To reset keep OK key pressed
for 3 seconds.
Picture Audio Settings
Projector
2453 hours
Settings
Display
Language
Keystone correction
Start-up screen
Lamp counter
System information...
Factory reset
(more)
Picture Audio
F
I
L
T
E
R
F
I
L
T
E
R
F
I
L
T
E
R
F
I
L
T
E
R
9. Maintenance
22