Philips PPF 725 Fax Machine User Manual


 
4 Philips · PPF 725 · PPF 755
EN
General Safety Information
Introduction 3
Your device has been tested in conformity with stand-
ards EN 60950-1 and IEC 60950-1 and should only be
operated with telephone systems and power equipment
that meet these standards. The device was built exclu-
sively for use in the indicated sales region.
Introduction 2
Do not make any changes or settings that are not de-
scribed in this user manual. Physical injury or damage to
the device or loss of data can result from improper han-
dling. Take note of all warning and safety notes indicat-
ed.
Setting Up the Device
The device should be placed securely on a stable, flat surface.
The device should be placed securely on a stable, flat
surface. If the device should fall, it can be damaged or
can cause injury to people, especially small children. Po-
sition all cables in such a way that no one will stumble
on them, thus avoiding possible injuries to persons or
damage to the device itself. If the device is dropped it
should be inspected by a technical service center.
The distance between the device and other appliances or ob jects, must be at least 15 cen timetres.
The distance between the device and other devices or
objects must be at least 15 centimetres; this also applies
to the use of additional cordless telephones. Do not
place the device in the vicinity of radios or televisions.
Lock the cover of the device completely into place
Lock the cover of the device completely into place when
opening the device. You could be injured if the cover
falls while you are working on the device.
Protect the device against direct su nlight
Protect the device against direct sunlight, heat, large
temperature fluctuations and moisture. Do not place
the device in the vicinity of heaters or air conditioners.
Observe the information on temperature and humidity
in the technical data.
The device must have sufficient ventilation
The device must have sufficient ventilation and may not
be covered. Do not put your device in closed cabinets
or boxes. Do not place the machine on soft surfaces
such as tablecloths or carpets and do not cover the ven-
tilation slits. Otherwise the device could overheat or
catch fire.
In the event that the device becomes too hot, or if you see smoke coming from the device
In the event that the device becomes too hot, or if you
see smoke coming from the device, you must immedi-
ately pull the power cable out of the power socket.
Have your device examined by trained professionals at
a technical service location. To prevent the spread of
fire, open flames should be kept away from the device.
Do not plug in the device in moist rooms.
Do not plug in the device in moist rooms. Never touch
the mains cable, the mains connection or the telephone
socket with wet hands.
Do not allow liquids to enter into the device.
Do not allow liquids to enter into the device. Discon-
nect the device from the power socket if liquids or for-
eign objects have entered the device and have your
device examined by trained professionals at a technical
service location.
Do not al low children to hand le the device without supervision.
Do not allow children to handle the device without su-
pervision. The packing materials should be kept out of
the hands of children.
Magnetic telephone handset
The telephone handset of the device is magnetic. Cau-
tion, small metallic objects (paper clips) may be retained
if placed near or on the telephone handset.
Power Supply
Check whe ther the mains voltage of your device
Check whether the mains voltage of your device (indi-
cated on the type label) matches the mains voltage avail-
able at the setup location.
Use only the power and telephones cables supplied.
Use only the power and telephones cables supplied.
The device does not have an o n/off key.
Set up your device so that the power socket is easily ac-
cessible. The device does not have an on/off key. In an
emergency, disconnect your device from the power
supply by pulling the power plug.
Never touch the power or telephone cable if the insulation is damaged.
Never touch the power or telephone cable if the insu-
lation is damaged. Replace damaged wires immediately.
Use suitable cables only; if necessary please contact our
technical customer service or your retailer.
Disconnect your device from the power and telephone networks during an electrical storm.
Disconnect your device from the mains and telephone
network during an electrical storm in order to avoid
electrical surge damage. If this is not possible, do not
use the device during an electrical storm.
Before cl eaning the surface of your device, disconnect it f rom the power and telephone n etworks.
Before cleaning the surface of your device, disconnect it
from the power and telephone networks. Use a soft,
lint-free cloth. Never use liquid, gaseous or easily flam-
mable cleansers (sprays, abrasives, polishes, alcohol).
Do not allow any moisture to reach the interior of the
device.
Only clean the displ ay with a dry, soft cloth.
Only clean the display with a dry, soft cloth. If the display
breaks, a mildly corrosive liquid may escape. Avoid all
contact with your skin and eyes.
In the event of a power failure, your de vice will not function;
In the event of a power failure, your device will not func-
tion; saved data is retained.
Repairs
Display
Should disruptions occur, follow the instructions on the
display and on the error report.
Repairs
Do not make any repairs to the device yourself. Improp-
er maintenance can result in injuries or damage to the
device. Only have your device repaired by an authorised
service centre.
Do not remove the type label from your device; this
would void the warranty.
Consumable Materials
Original Consumable Material
Use only original consumable materials. These are avail-
able from a specialised retailer or through our order
service (see back side of this user manual). Other con-
sumable materials could damage the device or shorten
its service life.
Environment
Dispose of old consumable materials according to the
waste regulations of your country.
1 General Safety Information