Filter
Top Products
7
Modeling Light:
The modeling light has three modes of operation:
1. MANUAL adjustment [press the MANUAL button, LED on] adjusts the modeling
lamp intensity with the MODEL slide control knob. As with flash power, minimum
setting is full left and maximum setting is full right. The MODEL intensity scale
corresponds to the FLASH intensity scale, measured in f-stops.
2. TRACK mode causes the modeling lamp intensity to track the FLASH control knob
setting. The modeling lamp may be set to full intensity at any FLASH control knob
position, by simply pressing the TRACK/SET button a second time, (you will notice
the TRACK/SET LED light blink once) with the FLASH control knob in the desired
position. Setting is retained when user returns from another mode.
3. FULL ON/OFF is exactly what it says. Press the FULL ON/OFF button to turn the
modeling lamp OFF (LED off) or ON (LED on).
All mode settings are retained, even after the power has been turned off.
PL1250 Accessories:
A Digital Display for the flash power setting is available as well as the large assortment
of PowerLight reflectors, umbrellas, softboxes, snoots, barndoors and cases. (See the
listing later in this manual)
PL1250DR and PL2500DR Accessories:
A Remote Digital display/flash control, a Remote Digital Display & Infrared Receiver
and a hand-held Infrared Controller are available, as well as the large assortment of
PowerLight reflectors, umbrellas, soft boxes, snoots, barndoors and cases. (See the listing
later in this manual)
1
6
32
7 8
4
9
5
tm