Filter
Top Products
16
<DRC1087>
En
CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN
Pin 1
Pin 1
DR - U16S
SCSI
Interface
Cable
Audio Cable
To the power supply of
the personal computer
SCSI HOST
Adapter
Sound Board
Into an expansion slot of
the personal computer
SCSI hard disk
Fig.4
When a SCSI hard disk or other SCSI equipment also is installed in the computer, please connect according
to the following method.
¶ Switch off the power supply of the personal computer.
¶ Set the SCSI ID number so that it is different from the ID numbers of all other SCSI units.
¶ Set the termination OFF.
¶ Connect the power supply cable from the personal computer. At the time of connection, pay
attention to the cable polarity. Please use a power supply cable with two or more connectors in
parallel.
¶ Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI connector is
connected correctly to pin 1 of the cable. Use a cable with two or more connectors in parallel.
¶ When a sound board is used, connect the audio output with an audio cable to the sound board.