Filter
Top Products
Troubleshooting 1
Communication Device may not be communicating to an active network port.
Try the following:
• Be sure the Network Cable ( ) is properly connected at both ends.
• Tryotherports(for10secondseach)untilyoundonethatisactive
(LED changes from solid orange to green). Do not use a network port in a
computer.
• Pull the power connector ( ) out, then reconnect power to restart the
Communication Device.
• If after 45 seconds, the right LED is still not blinking orange only, consult your
IT specialist. Your IT specialist may need to follow the Special Network Settings
procedure on page 6.
For more detailed technical assistance, go to: www.pb.com/support/LAN
If the right LED is solid orange (not blinking), follow Troubleshooting 1, below.
Installation Part 1 - Set Up Communication Device
3
Plug the AC adapter ( ) into the Communication Device and a
power outlet. The left LED is lit yellow when it is on.
4
Apply power to Communication Device
LEDs
AC Adapter
Communication
Device
5
Check LED
After 45 seconds, the right LED will blink orange, go to Step 6
LEDs