Pitney Bowes K700. K7M0 Postal Equipment User Manual


  Open as PDF
of 32
 
Installation Part 1 - Set Up Communication Device
8
ConrmConnection
DO NOT press Enter on the meter yet.
For wireless connection and meter setup go to Step 9 on page 7.
About 10 seconds after the meter completes its startup routine,
it displays the message:
Also, the right LED changes from
blinking orange to blinking green only.
If the right LED lights orange, either solid or blinking,
see Troubleshooting 2 below.
LEDs
5
Meter connected to
internet-Press Enter
Troubleshooting 2
If the meter does not display the message, “ Meter connected to Internet”,
your meter is not communicating with the Internet.
Try the following:
• Check that the USB Cable ( ) is connected properly.
• If the right LED is solid orange (not blinking), then the network cable is connected
toaninactiveport.Tryotherports(for10secondseach)untilyoundonethatis
active (LED changes from solid orange to green).
• Restart the Communication Device by pulling the power connector ( ) out, then
reconnecting the power.
• If, after 60 seconds the message, “Meter connected to internet” is not displayed,
consult your IT specialist.
Your IT specialist can refer to online troubleshooting assistance at:
www.pb.com/support/LAN
 previous next