Filter
Top Products
GETTING STARTED
6
LPS-1 Components
Button descriptions
The functions of the buttons on the LPS-1 are described below.
LED Lamp
LED lamp on the LPS-1 indicates the current operating condition.
Button Condition
ON/OFF button Turns power to the LPS-1 on and off.
FEED button
• When using LA Die-cut Labels, feeds the LA Label Roll to the beginning
of the first label on the roll. If this button is held for more than one
second, the LA Label Roll is fed to the beginning of the next label on the
roll.
• When using LA Continuous Tapes, feeds 1" (25.4 mm) of the LA Label
Roll.
• If there is no LA Label Roll installed, the mode changes to a cleaning
mode and the roller rotates for 1/3" (8 mm). If this button is held for more
than one second, the roller rotates for 4" (100 mm).
Lamp Condition
Not lit
Power is OFF.
Lit
Power is ON.
(Normally lit while power is on, the LED flashes during cleaning or if an
error has occurred.)
Flashing fast
Indicates one of the following errors.
• Cutter error
• Label sensor error
(LA Roll not installed correctly, end of LA Roll, or label jam)
• LA Roll compartment cover is open during operation
• Incorrect LA Roll installed
• No LA Roll installed
Flashing slow
Cooling
(Waiting for temperature of print head to lower)
Turns off after flashing
fast ten times
System error
Turn the LPS-1 off and then on again.
If this error re-occurs, please contact Pitney Bowes Service Express at 1-
800-522-0020.