Filter
Top Products
Pitney Bowes W660/W680 Operator Guide 3-11
W660/W680 Basics • 3
4. Position the Sliding Fence
Setting Up A
Job (continued)
Your printer comes with two sliding fences—a long one and a
short one. Use the long fence for number 10 envelopes and larger
materials. Use the short fence for materials smaller than a num-
ber 10 envelope.
To position the fence:
1. Place a sample piece or trial stack of material in the input
area.
2. Slide the fence until it almost touches the stack of
material.
3. Check that there's about 1/16" clearance (the thickness of
adime) between the fence and the stack.
NOTE: Proper clearance is important. If you push the fence
tight up against the stack, it could retard feeding and cause
jams. If the clearance is too great, pieces could skew as they
feed into the printer.
Sliding Fence