Filter
Top Products
iii
U.S. Federal Communications Commission (FCC) Requirements
This device was tested and complies with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
There is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
To comply with the limits for an FCC Class B computing device, always use
the shielded signal cord supplied with this unit. The FCC warns that changes
or modification of the unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Canadian Documentation Notice - Class B Computing Devices
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the Radio Interference Regulation of the Canadian Department of
Communications.
“Le present appareil numerique n’emet pas de bruits radioelecinques depassant
les limires applicables aux appareils numeriques de la class B prescrites dans le Reglement
sure le brouiliage radioelectrique edicte par le minstere des Communications du Canada.”
Regulatory Compliance
This system was tested and complies with IEC/EN 60601-1, UL 2601-1, and CAN/CSA C22.2
No. 601.1 medical safety standards. It is the system integrator or configurer’s responsibility to
test and ensure that the entire system complies with applicable electromagnetic compatibility
(EMC) laws.