Filter
Top Products
FNSW-16/2400S User’s Guide
9
23 24
19 20
Reset
Port Type Cable Type Connector
10Base-T
Cat 3, 4, 5 RJ-45
100Base-TX
Cat.5 UTP only RJ-45
100Base-FX*
62.5/125µm multi-mode fiber
ST / SC
Table A: Supported port list
2.2.3 MDI Switch
Each numbered port of the Switch are MDI-X port, you can
direct use straight cable for the connection to your end nodes.
However, port 12/20 is with one push button. To push the button
to convert the port to MDI-II port for direct hub cascade. Please
also refer to Section “RJ-45 Pin Assignment” for more.
2.2.4 Status LEDs
One green LED to show power On/Off is on the front panel, and one
“Module Installed” LED indicator to indicate the rear open slot is
installed with a fiber-optic module. Also, each port has three status
LED indicators, as shown below.
LABEL
STATUS /
COLOR
MEANING DESCRIPTION
Steady
Amber
FDX
Lit to indicate Full-Duplex mode
detected on that port
UPPER
ROW
Blink
Amber
COL
Blinks if a collision is detected
when the port is in Half-Duplex
mode.
Steady
Green
Link
Lit to indicate that a valid physical
UTP/STP connection is detected
MIDDLE
ROW
Blink
Green
Activity Blink to indicate the port is
receiving data packets