Filter
Top Products
Pass Phrase
The middle panel is to configure the Access control of the SNMP. Click the Set Access Config
button to load the settings.
The parameters at this section
From WAN Interface
Check the checkbox to allowed the access from WAN device to SNMP
From VPN Interface
Check the checkbox to allowed the access from VPN device to SNMP
From Network Interface
Check the checkbox to allowed network to access the SNMP
Subnet
The Subnet IP Address of the allowed network. This field is disabled if From Network
Interface is disabled
Netmask
The Netmask, corresponding to the Subnet IP Address, of the allowed network
The bottom panel allowed user to configure details regarding the SNMP Trap. Click on the Set
Trap Configurations button to enable the settings.
The parameters at this section
Enable SNMP Trap
Check this option to enable the use of SNMP Traps
SNMP Trap Version
Specifies the SNMP version used for the SNMP Trap. Three options are available: SNMP
v1 or v2c, SNMP v3, and both
Destination IP Address
Specifies the destination IP Address to send the trap message to. Fill in the IP Address of
the Trap Viewer will enable the Trap Viewer to capture the trap release by this node
54