Filter
Top Products
3
Chapter 2 Hardware Installation
Please refer to the steps below to install your HDD into NAS-1100:
1. Loosing the two screws on the rear panel by screwdriver or hands.
2. Grabbing the front panel and separate the HD holder from case.
3. Your HD jumper should be set to Master. Different Hard Disk has different jumper settings; please
refer to your Hard Disk manual for correct setting.
4. Insert the IDE connector into the IDE socket of the Hard Disk. Make sure the pin 1 on the cable is
connected to pin 1 on the HD socket. Pin 1 is the red or pink strip on the edge of an IDE cable. The
IDE cables are designed so that it will only go in one way, which will correspond to pin 1.