Filter
Top Products
SIP Voice Gateway User’s Manual
Command Line Interface
67
Dialplan configuration default parameters:
a) Log on VIP via telnet or console connection.
b) At the ITG prompt, insert following commands:
ITG>atpm erase
ITG>net reset (Answer ”y” to reboot machine.)
After rebooting, logon VIP. At the ITG> prompt, insert: atpm store to restore Dialplan default
value into VIP.
A sample is attached below for reference.
ITG>
atpm erase
The dial plan will be erased from non-volatile storage permanently.
Are you sure to erase it (y/n)? [n]
y
Dial plan erased from flash
OK
ITG>net reset
============================== WARNING =============================
* Restarting the system will hang up all telephone connections *
* and all the configuration settings will lose. *
* Be certain all the configuration settings have been saved. *
====================================================================
Do you want to restart the system now (y/n)? [n] y
Boot loader V4.12
Mem 16b 16M
Loading application
code........................................................................................................................
******* Internet Telephony Gateway (PLA) Version s1.0 *******
****************** Hardware Configuration ******************
Flash: type-MX29L1611 32 sectors 64 KB/sector
RAM: 8 MB 512K x 16
LAN: auto-negotiation on-going. Link DOWN
TIM slot A: type-FXO2S2 DSP-C5409 codec-PEB2466 Diag-OK
************************************************************
ITG>No dial plan info can be found in the Flash, the default dial plan is used but NOT saved.
OK
ITG>
atpm store
OK