Filter
Top Products
Case 2: (Peer-to-Peer mode) VIP-157S Port 1 to Port 2 communications
Supposing one VIP-157S connects to two telephones, just pick up phone 1 and dial
‘192*168*0*1**5062’, phone 2 will ring.
Analog telephone sets are connected to the phone (RJ-11) ports of VIP-157S respectively
192.168.0.1
1001
1002
50
Test the scenario:
1. Pick up the telephone set on VIP-157S port 1, and you should be able to hear the dial-tone
2. Press the keypad: 192*168*0*1**5062# shall be able to connect to the VIP-157S port 2
3. Then the telephone set in VIP-157S port 2 should ring. Please repeat the same dialing steps on
port 2 to establish the first voice communication from VIP-157S
1 9 2
* 1 6 8 * 1
** 0 0 6 5 2 #
*
y If the IP address of the remote calling party is known,
you may directly make calls via its IP address and end
with a “#”.
y If the ATAs are installed behind a NAT/firewall/IP
sharing device for Peer-to-Peer VoIP application,
please make sure the NAT device support SIP
applications, and suitable settings should be applied
to the NAT device to enable the SIP communications
before making calls
y [VIP-157S] in PLANET ATA series products, to connect
to remote ATA, press the keypad in the following
sequence to connect to the remote VIP-157S port 2:
[remote ATA IP address]**5062, for example:
192*168*0*2**5062
L Hint