Filter
Top Products
62
Provide "Respond to
Auto-configuration"
setting
If enabled, the "Respond to Auto-configuration" setting
on this AP is supplied to the AP making the Auto-
configuration request. If disabled, the AP making the
Auto-configuration request will keep its existing setting.
Auto Update
Check for Firmware
upgrade
If enabled, this AP will check to see if a Firmware (FW)
upgrade is available on the specified FTP Server. If
enabled:
· Enter the desired time interval (in days) between
checks.
· Select the desired option for installation (see next
item).
· Provide the FTP server information.
Install...
Select the desired option:
· Install FW if different version found
If selected, and the firmware file at the specified lo-
cation is different to the current installed version, the
FW will be installed. This allows "Downgrades" -
installing an older version of the FW to replace the
current version.
· Install later version only
If selected, the firmware file at the specified location
will only be installed if it is a later version.
FTP Server address
Enter the address (domain name or IP address) of the
FTP Server.
Firmware pathname
Enter the full path (including the FW filename) to the FW
file on the FTP Server.
FTP Login Name
Enter the login name required to gain access to the FTP
Server.
FTP Password
Enter the password for the login name above.
6.4 Config File
This screen allows you to Backup (download) the configuration file, and to restore
(upload) a previously saved configuration file.
You can also set the WAP-4060PE back to its factory default settings.
To reach this screen, select Config File in the Management section of the menu.