Filter
Top Products
Detailed setup 13
NTSC/PAL/SECAM
Place the projector on a tabletop or other level surface
video connections
with the lens facing the projection screen.
1 Connect one of the yellow RCA composite video cable
(part number CA19) plugs into the VIDEO OUT jack of your
video source. Connect the yellow plug at the other end of
the cable to either of the SOURCE 1 or SOURCE 2 video-
input composite jacks (yellow) on the projector connector
panel (see the illustration below).
Composite video
connections
The projector is also compatible with S-video sources
(for the appropriate connections, refer to the illustration on
the next page).
Note: You must connect audio and video sources to the
same source channel if you plan to select them simultane-
ously.
2 Connect the red RCA audio-video cable plug to the AUDIO R
(right) jack of your audio source. Then connect the red plug
at the projector end of the cable to a red audio jack (either
SOURCE 1 or SOURCE 2 R) on the projector connector
panel.
LR
SOURCE 1
VIDEO INPUTS
L R STEREO
MAC / PC
STEREO
PC / MAC
STEREO
REDRIVE
LR
RS 232
SOURCE 2 SOURCE 3 SOURCE 4 OUTPUTS
COMPUTER INPUTS
SOURCE 2
Audio/Video cable
VCR or laser disk player
AUDIO
LR
VIDEO
S-VIDEO
Use SOURCES 1 and 2 to
connect more than one
audio/video device
(one cable per device)
White
Yellow
Red
White
Red
Yellow
SOURCE 1