Chapter 1- Hardware Description
1-28
• Partially Open - For card powering down mode. Partially open the
ejector lever(s) until the blue HS LEDs on the card and the Control
Unit start flashing. When the HS LED is constantly lit the card is in a
powered down mode and you can remove the card.
• Fully Open - In this position the card is released from the MCU
housing and can be removed.
Replacing the CNTL Module
The CPU module is the management system of the RMX 2000. Use the
following procedure to replace a CNTL Module:
1 Ensure that power switch on the RMX 2000 is turned OFF (O).
2 Unscrew the captive screws on the front panel of the RMX 2000 that
secure the
CNTL Module.
Handle
Unlocking the Lock Catch - With your index
finger holding the “handle” and your thumb shifting
the catch to left, gently pull the handle away from
the chassis until the lever is “fully open”
Closing the Lever - Make sure that the lever is in
an open position and push card close to the
chassis till the lever engages. With your index
finger holding the “handle” and your thumb holding
the catch fully to left, push the card against the
chassis whilst closing the lever. Use your thumb to
push the card into place by pushing your thumb to
the right and locking the catch into a locked
position. Make sure that the lever is locked.
Warning!
Once the removal sequence is initiated the process cannot be terminated and
the HS led flashes when activated.
Lever Fully Open - Pull the lever handle(s) to a
fully open position (approx. 70 degrees), as
shown here