Filter
Top Products
Polycom RMX 4000 Hardware Guide
1-31
.
ISDN/PSTN Clock Source
Each RTM ISDN card has its own primary and secondary clock source.
The first span to synchronize becomes the primary clock source and the
second span to synchronize becomes the secondary clock source. This
clock is used to synchronize ISDN spans only (it is not the system clock).
A single clock source triggers an alarm that can be turned off by setting
the appropriate flag in the system configuration.
RTM LAN
The RTM LAN card routes data between the MPM+/MPMx cards and
components of the system, sends media by IP packets and provides
connectivity to external networks.
An RTM LAN card must connect directly to an MPM+/MPMx card. In an
RMX with a single MPM+/MPMx card, the RTM LAN card must be
installed in the rear panel slot on the
same level as the
MPM+/MPMx
card.
Each RTM LAN card includes 2 LAN ports and a maximum of four RTM
LAN cards can be installed on the RMX 4000.
Figure 1-13RMX 4000 RTM LAN Rear Panel Layout
With the RMX 4000, you can either have a dedicated E1 or T1 Type Network
Service. It is not possible to have a mixed E1 and T1 ISDN Network Service.
2 LAN Connections &
LEDs