Filter
Top Products
OPERATION
EATON Powerware
®
Energy Management System (EMS) Upgrade Kit User’s Guide S 164201724 Rev 1 www.powerware.com
42
Setup Options
Access to setup options is restricted to three System Setup Levels: 0, 1,
or 2. The higher the level, the more setup options are available. Options
on System Setup Level 0 do not require password access.
Table 9. Setup Options
Minimum
Level*
Description Available Settings Default Setting
0 Enter Password Use the arrow keys to enter the password for the level you
want to access, then select DONE to display the options for
the setup level
Level 1: L1
Level 2: Contact your
service representative
0 Versions Read only Current firmware
versions installed
0 Contrast Adjust Adjust screen contrast with left/right arrow buttons 10%
1 Log Out Exit the Level 1 or Level 2 setup options and display the
Level 0 setup options
None
1 Change Access
Level Password
Change the password for the current setup level
Use the arrow keys to enter the new password (A–Z, 0–9, –,
blank,), then select DONE to save the new password.
None
1 Set Date and Time Set Month, Date, Year (mm/dd/yyyy)
Set Hour, Minute (Time is a 24−hour clock.)
00/00/0000
00:00
1 Clear History Clear the History Log None
1 Clear Load Profile Clear the Load Profile None
1 Building Alarm
Setup
(see page 53)
For Building Alarm 1 through Building Alarm 4:
Name String [up to 19 characters (A–Z, 0–9, –, blank)]
Settings: Contact Normally Open or Closed
Building Alarm Type (REPO, EPO, TVSS/SPD,
Custom)
Notice Level (Log and Alarm options)
Enabled/Disabled
BUILDING ALARM [X]
Open
1 and 2: Custom;
3: REPO; 4: EPO
Log Only
Enabled
1 THD Alarm Level Set the voltage and current Total Harmonic Distortion for
Input 1 and Input 2, and enable or disable this feature:
THD settings
Enabled/Disabled
5.0
Disabled
2 Unit Type Read only: Model / CTO / Serial Factory−set identifiers
2 Unit Name Up to 19 characters (A–Z, 0–9, –, blank) EATON EMS−UGK
2 Reset All Lower
Level Passwords
Reset the Level 1 password to the default setting None
* Minimum System Setup Level required to access the setup option.