Filter
Top Products
Installation
28
Powerware
®
5115 Rack-Mount User’s Guide : 164201449 RevA www.powerware.com
Communication Port
10A, IEC-320 Input Connector
DIP SwitchesUSB Port
Four 10A, IEC-320
Receptacles
Network Transient
Protector
Input Circuit
Protector
X-Slot
Communication Bay
Figure 12. 500–1500 VA, 230V Rear Panel
5. Plug the UPS power cord into a power outlet.
The UPS is in Standby mode with the equipment offline. All
indicators are off.
6. Press and hold the
button until you hear the UPS beep
(approximately two seconds).
The front panel indicators cycle through a startup sequence
while the UPS conducts a self-test. When the self-test is
complete, the UPS enters Normal mode. The
,Load1,and
Load 2 indicators illuminate indicating that power is available
from the UPS output receptacles.
If the alarm beeps or a UPS alarm indicator stays on, see Table 8
on page 48.
NOTE Thebatteries charge to 90% capacity in approximately 3 hours. However, it is
recommended that the batteries charge for 6 to 24 hours after installation or long-term
storage.