Filter
Top Products
28
Powerware
®
5115A USB User’s Guide • www.powerware.com.au
Table 8. Troubleshooting Guide (continued)
Alarm or Condition Possible Cause Action
3 beeps Failed attempt to start the Plug the UPS into a power outlet for 24 hours to
every 10 UPS on battery. charge the battery. After charging the battery, press
seconds and hold the button for 3 seconds.
Then check the indicator. If the still
flashes, see “UPS Maintenance” on page 15 to
replace the battery.
Continuous The output wave is Shutdown is imminent. Save your work and turn off
beep abnormal while the UPS is your equipment. Turn off the UPS. Contact your
on battery. service representative.
Continuous The output voltage is below Save your work and turn off your equipment. Turn off
beep or above the limit while the the UPS. Contact your service representative.
UPS is on battery.
Troubleshooting