Filter
Top Products
15
Powerware
®
3110 User’s Guide S Rev B www.powerware.com
CHAPTER 5
TROUBLESHOOTING
The front panel LEDs and an audible beep indicate the UPS status (see
Table 6). The UPS beeps whenever the unit is on battery power or an
alarm is present.
Table 6. Troubleshooting
Alarm or Condition Possible Cause What to Do
Normal operation. None. The UPS is operating in Normal mode.
Line loss due to:
S Utility power outage.
S Wait for utility power to return.
S Loose plug connection. S Check the power cord connections.
1
b
e
e
p
e
v
e
r
y
5
s
e
c
o
n
d
s
S Tripped circuit breaker. S Reset the circuit breaker.
1 beep every 5 seconds.
S Power cord failure.
S Contact your service representative for a new power
cord.
2 beeps every 5 seconds.
Low battery alarm; shutdown is
imminent.
Prepare for a UPS shutdown. Save your work and turn
off your equipment.
The unit automatically restarts when acceptable power
returns.
3 beeps every 5 seconds.
The battery needs charging or
service.
Turn the UPS off and plug the UPS into a power outlet
for 24 hours to charge the battery. Turn the UPS on to
test the battery. If the alarm still beeps, see “Replacing
Batteries” on page 9 to replace the battery.
3 beeps every 5 minutes.
The battery is discharged and
battery power is not available.
The UPS automatically recharges the battery. The alarm
clears when the battery is recharged.
N
NN
NO
OO
OT
TT
TE
EE
E If the UPS has not recharged the battery after
24 hours, the alarm changes to 3 beeps every 5 seconds
and the battery must be replaced. See “Replacing
Batteries” on page 9 to replace the battery.